MODEL _MD2_Inv2_N VSWITCH Roff=1e6 Ron=1 Voff=0.1V Von=4.9V MODEL _MD2_Inv2_P VSWITCH Roff=1e6 Ron=1 Voff=4.9V Von=0.1V MODEL _MD2_Inv1_N VSWITCH Roff=1e6 Ron=1 Voff=0.1V Von=4.9V MODEL _MD2_Inv1_P VSWITCH Roff=1e6 Ron=1 Voff=4.9V Von=0.1V S_MD1_Trig2_PTrig MD1_Trig2_4 VSS MD2_Nor3b_2 VSS _MD1_Trig2_PTrig
X_MD1_Trig2_Comp SD MD1_Trig2_3 MD2_Nor3b_2 com COMP S_MD1_Trig1_PTrig MD1_Trig1_4 VSS MD2_Inv1_1 VSS _MD1_Trig1_PTrig X_MD1_Trig1_Comp HIN MD1_Trig1_3 MD2_Inv1_1 com COMP S_MD1_Trig3_PTrig MD1_Trig3_4 VSS MD2_Inv2_1 VSS _MD1_Trig3_PTrig X_MD1_Trig3_Comp LIN MD1_Trig3_3 MD2_Inv2_1 com COMP SUBCKT IR2110 VDD HIN SD LIN VSS HO VB VS VC COM LO * (4) The "Low side return (COM)" pin must be grounded. * for the proper modeling of turn-on rise/turn-off fall time.
* (3) The values of output high/low short circuit current are adjusted
* (2) The power dissipation is different. * (1) There is no frequency effect on temperature. * This behavioral model was developed in compliance with Data Sheet
Qucs checker error no actions defined driver#
* LIN: Logic Input for Low Side Gate Driver Output (LO), in phase * HIN: Logic Input for High Side Gate Driver Output (HO), in phase
Qucs checker error no actions defined code#
I'm trying to simulate the IR2110 in proteus ISIS (is not modelled nativelly), then I've downloaded the model from infineon and followed the tutorial from labcenter to make de device, after make the device then I tried to simulate the new device but I'm having an error in PROSPICE which says "Too few parameters for subcircuit type "IR2110" (instance: xU2)" where the code of the model is the following: **********************************************************************
0 kommentar(er)
